Pretty in Pink

We are going to make a tag using the art of ©Sonia Roji.

You can buy her art at www.mypsptubes.com

The scrapkit I have used can be purchased from http://designerscraps.com/ for only $3!

Ok let's start

right click and save the mask to your masks folder, this mask is by Becky

Open a new 500x500 canvass and flood fill white

Using a paper to match your tube, paste it as a new layer above the white layer and apply your mask, remembering to merge the group.

now add your frame and go to Image--> Rotate--> and rotate it slightly I rotated mine left by 11.0.

Now to make your tube look as though it is stepping over the frame, paste your tube onto the tag and position it above the frame,

When you think you have it in the right place, duplicate the layer and drag this layer to underneath the frame layer.

You should now have

1st layer white
2nd layer the mask layer
3rd your tube
4th your frame
5th the tube again.

Now choose your eraser tool and making sure the top tube layer is active, delete the parts of the tube that should be hidden underneath the frame and leave the leg over the top of the frame,

This gives a clean and crisp edge on the tube, if you wish to add a dropshadow you need to apply it to the tube layer underneath the frame.

Now in every kit you use you always have the fancy bow and buttons sometimes flower branches like in the kit I have used, it is entirely up to you how you decorate the tag.

I chose to keep it simple on the left hand side.

As you can see there is a shadow of the tube underneath so all I did was again duplicate the underneath tube layer and lower the opacity to between 15-20 and shifted them around underneath the tag.

good effect huh?

All you need to do now is add your copyright and your tag is ready to show off!